S
Mobula 6 Freestyle Losing Power After Crash: Need Help!
Hey 👋
I’ve been having fun learning with a Mobula 6 Freestyle. It’s been performing great and taking it like a champ.
However, today after a crash, it’s been having odd performance. When I fly it’s like it’s got no power, even at full throttle. I can’t see any visible damage on the drone/motors/aio board.
So I wondered if anyone else here might have had a similar thing happen and or might know what the problem could be? :)
Thanks,
Happy flying 🙌
👋 1
L
87sem.
Check the motor bell, it can begin to separate, you might need to squeeze it with pliers to get it sandwiched back together.
Répondre
S
87sem.
Auteur
@lastonleftfpv thanks for the reply :).
Looking at the motors, I don’t see any separation on any of the motor bells.
Thank you very much for the suggestion though:)
Répondre
87sem.
@Spacepud make sure that the battery is fully connected securely, as a small connection can limit the flow of power
👍 1
Répondre
S
87sem.
Auteur
@spacemanfpv thanks I’ll test again and make sure the battery is fully seated. Appreciated 🙌
Répondre
87sem.
Potentially a loose prop? Does it make funny noises?
👍 1
Répondre
S
87sem.
Auteur
@Caffeine just had all the props off to inspect. They definitely weren’t loose 😅. But I did notice that it looks like one prop seems to have been slightly bent at some point (see through plastic has a line through it looking like a bend). I’ll try putting all new props on and test.
Big thanks for the suggestion ^-^
Répondre
86sem.
Have you figured this out? I would recommend plugging it in to BetaFlight to run some tests on it. Take the props off and spin the motors and check what the readings on BetaFlight say. That could tell you some information. It could be some lose or poor connections between motors and AIO or even the battery leads could have come lose where they're soldered to the AIO.
👍 1
Répondre
S
86sem.
Auteur
Hey thanks for the suggestions :). I’ve been away for some days. But I did check the motors in Betaflight. And motor 4 is having problems.
When checking the motor, it seems the pin is slipping as if it’s not fully gripped by the motor itself (if that makes sense).
So I’m guessing I killed that one motor, I cannot figure out exactly how to get the motor to grip the pin tightly again, it’s so tiny 😅
Répondre
A
Laisser un commentaire