Publicación en el foro
Hello, I just recently built my first fpv drone and I ran into an issue.
Sometimes when I decrease the throttle on my remote the motors keep spinning at the same speed. I flashed the firmwere yesterday and it all seemed fine in betaflight. How do I fix this?
12sem
is this when you first arm your drone. the motors spin at a minimum amount when you are armed.
Responder
12sem
Autor
No, I arm the drone, then I add some throttle to check if everything works fine and when i lower the throttle the motors keep spinning at the same speed or start accelerating until I disarm the drone
Responder
E
12sem (editado 12sem)
Esta respuesta se ha eliminado y ya no está disponible.
12sem
12sem (editado 12sem)
Autor
Esta respuesta se ha eliminado y ya no está disponible.
12sem
Same happened to me - I did some research and it seems that this can happen on the bench when you have the props off. At least that is what I hope it is as I have not done a test flight yet. 👍
Responder
12sem
Autor
Ok, thank you for helping!
👍 1
Responder
A
Deja un comentario