L

LordPickle

最近在线:11月22日 05:30
粉丝
2
已关注
3
赞同
0
帖子
1
Whats good gang

动态

2026年11月22日 05:30

评论了 的帖子
but if youre gonna buy hv packs, youre usually buying them for the extra performance, not for longevity of the battery... a toss up between 10% more performance and 10% more cycles

2026年10月20日 08:09

评论了 的帖子
Flying behind you or placing buildings or large metal/concrete structures between you and your quad can have a significant impact. Other causes are busted antennas or antenna cables. Check and see if the antenna cables on your quad aren't kinked somewhere, if they are it's a new antenna for you. Also check you're not in a low power mode or pit mode in your goggles. If you're consistently flying in the same location, try selecting a different channel if you can. There may be some interference messing with your signal coming from somewhere near your flight location.

2026年9月13日 20:42

评论了 的帖子
Are you running 3s? The vid shows voltages around the 10-11 mark, so im assuming thats not 4s right...

2026年9月5日 23:43

发布了一篇帖子

RC Lawnmower Build


No, I'm not just building a 15" cinelifter. Just tossing around ideas for a diy rc lawnmower, instead of dropping 4k on one. Final product would probably end up costing a similar amount, but this way i get to learn stuff as well. I'm thinking this would either be running off of a 12v lead acid battery, along the lines of a car battery, or an 8s or 12s lithium pack. Probably looking at an 18" metal blade, and aiming for around 2500-3000 rpm. That gives a tip speed of ~140m/s, so no worries there. I could potentially go with 2 power systems, 8/12s for driving the blade and 12v for driving the wheels. I'm mainly just looking for potential parts recommendations here. Ideally I can run this using elrs, cause then I don't need a new radio, but I'm also aware that this is not exactly the intended use case for elrs. Also tossing up whether I go with a big powerful servo and rc car style setup for steering, or something more along the lines of a rack and pinion setup with a geared down brushless motor. Thanks for any input

2026年8月4日 11:06

评论了 的帖子
He wanted good replacements Stu!

Jokes aside, if you're replacing darwinfpv motors, probably a good idea to get something better that doesn't have darwins rep for quality control. I've got the xing2 1404 4900kv motors on my 3" and they seem solid enough, but I've also heard since buying them that they're some of the lower performing 1404 4900kv motors out there. Take a look at some of chris rossers motor comparision vids, they're good @AlmondKing 

2026年8月4日 11:00

评论了 的帖子
Yeah, 3d modelling is hard until you crack it, then its still hard but it makes sense. Nice quality prints as well. I'd suggest making sure the motor screws aren't clamping down on the tpu though, soft mounted motors aren't amazing. You may lose a guard every now and again, but its better than losing a motor

2026年8月2日 00:50

评论了 的帖子
Yep, most of those 1.6"-2.5" betafpv whoops are a good idea, they all seem to be fairly solid and simple. Watch some yt reviews on them and some flight footage, see what you like

2026年8月2日 00:46

评论了 的帖子
Ive had m4 nuts vibrate off of matching bolts after being cranked down, simply with small brushed hobby motors. Get some blue loctite and apply it on the threads of your screws, and crank them down. That should hold them in. Or you can go fancy and buy some standoffs with nylock inserts in them, thatd also do it. But yeah darwinfpv is known for being fairly sub par

2026年7月27日 07:34

评论了 的帖子
Eh, on paper binocular goggles are better than box goggles, but also a good set of box goggles will often feel better than a bad set of binocular goggles, especially with a topstrap. But its fair enough if you're set on not going down the hdz route, between walksnail and dji you can usually get close to most of the hdz advantages

2026年7月27日 06:50

评论了 的帖子
HDZero boxpro and walksnail vrx! The boxpros have analog and hdz built in, and a hdmi in port so you can slap a vrx on it as well. Should also be a similar price to those options. You can also get hdz whoops later on or run hdz on your larger quads

2026年5月13日 20:56

评论了 的帖子
I personally think 3" is good to start off with, as long as you're planning on building instead of buying a prebuilt. I started with a 3" volador, (still my only quad btw) and its got enough power to fly outside really easily, but its still small enough that it doesn't sound like a small child being thrown through the air. If you plan to go bnf though, 65 or 75mm is probably best

2026年5月6日 05:08

评论了 的帖子
I believe the hdzero boxpros also have a hdmi port, I'm not up to date on how much they cost but they're good value for the money

2026年5月3日 05:11

评论了 的帖子
I'd have a look at boat prop development, I think that you may find a good starting point there. They're larger scale so small innefficiences and vibrations are noticed more, and have been developed and messed with a lot more as well.

2025年12月6日 07:05

评论了 的帖子
Those motors look absurd on the 3" lmfao! Gonna be fast though. What motors are they, I'm assuming 6s?

2025年10月28日 23:45

评论了 的帖子
Can relate, thats my biggest problem with the 15-20 minute life on my dji mini 2! Average temperature where I am is usually 10 degrees celsius, so unless I've got my good gloves on I can't stand it

2025年10月23日 19:43

评论了 的帖子
Even just having 2 tpu plates stick out infront of it would help massively, only has to be a couple mm's. Good luck with it

2025年10月22日 04:48

评论了 的帖子
Looks great man, I'm yet to get my vx3 build up and running but I'm looking forward to it. Just a suggestion, see if theres another hole on the camera mounting plates that you can put the camera on. Having it sticking out like that is likely to damage it in a crash.

2025年8月5日 10:08

评论了 的帖子
@Uri-Nator87 On 2450kv motors, almost definetely 6s. Just be sure that your stack can handle 6s

2025年8月4日 05:53

评论了 的帖子
Probably just try a couple of different sized 6s batts, from a reputable brand like tattu or gnb or something. Maybe something 600-1000mah, just see what combination of weight and flight time you prefer.

让我们一起起飞,把 FPV 穿越机的世界带上新高度。

产品目录
帮助与法律信息
© 2026 DIYFPV。保留所有权利。