Hi. I got a drone kit for christmas but am struggling to get the goggles/glasses working?
The goggles are some second hand sky zones but the drone kit was new. I believe they are compatible, both being “analog”? I think I have everything set up correctly.
When I plug everything in it looks like it's ok but I can not see any picture. I can see numbers about my battery and when I flick a switch it says “armed” but no actual camera video?
The reason you can see the battery info is because that’s a completely seperate system than the camera feed, as the OSD gets added to whatever input signal it has from the camera and then it gives the signal plus the OSD to the VTX, so the Flight controller working, butyour camera is disconnected or broken
the camera connects to the fc camera in and the vtx connects to video out. Video out will always display the osd even if there is no camera connected.
PIT Mode? Have you tried arming? On mine it did that the first time and when I armed (acro no throttle) it worked
The reason you can see the battery info is because that’s a completely seperate system than the camera feed, as the OSD gets added to whatever input signal it has from the camera and then it gives the signal plus the OSD to the VTX, so the Flight controller working, butyour camera is disconnected or broken
THANK YOU!! This was driving me nuts. After this comment I replaced my yellow wire from my camera to my flight controller and it worked. So everything was working it was just a broken wire between the two. I just assumed my camera or something was broken because I could see the "osd" but no image. you just saved me $30. Thank You.
A genius is in our midst…
I can take a picture when i get back home but if the camera is broken why can I see the battery info etc?