No OSD, but everything work great

miloTheGreat asked this question

miloTheGreat

61w

Hey Crew,

I really hope you can help, I'm at a loss and really want to get this thing off the ground :)

I have a BetaFPV F722 and a Axis Flying Smurf VTX 5.8, connected to a Runcam Pheonix 2 pro

Controller

https://betafpv.com/products/toothpick-f722-2-6s-aio-brushless-flight-controller-35ablheli_s?variant=40075614126214

VTX

https://www.axisflying.com/products/smurfs-vtx-58g-16w-analog-image-transmission?VariantsId=10498

RunCam Pheonix 2 pro

https://www.runcam.com/download/Phoenix2/Phoenix_2_Manual.pdf

Everything seems to be running fine, however there is not OSD, it is enabled in BF just nothing in the goggles but the camera view...

Any ideas?

4 comments

Don_Cannelloni

61w

Check if you had set your osd in the OSD tab to analog (PAL or NTSC) and not hd.

Adrenadrone

61w

I had a similar issue because I originally flashed the flight controller with the wrong OSD option. I chose HD instead of analog. Just had to save my Dump All CLI, reflash, load and save the CLI and all was good. Good luck

GreenthumbFPV

61w

Possible you've selected wrong firmware option (SD Vs HD) or that you've selected wrong options in Ports tab.

What UART is your VTX on , and is it Tramp or Smart Audio ? ( I can't read your screenshots)

ecsFPV

55w

Try it on a other UART - sometimes it´s

help

Restricted area, only registered members can post comments.Log in Sign up

5 participants