Darkbrewery
Kanał aktywności
24 września 2026 00:10
5 września 2026 02:38
21 lipca 2026 17:03
For the images they are checking into why permissions aren't set for users to upload custom images. For the grid issue, have you tried zooming in closer for a tighter snap grid? Also I find that using the arrow keys helps nudge parts in finer increments than dragging with the mouse does.
Then for the component stacking yeah, that's annoying. For now its whatever is added last gets the higher z index value. Labels and silkscreens have to be added as a final step or they do get covered up.
For your two sided part, does it let you assign the same image for both front and back?
For anyone reading and building... We can currently only publish one version of each part. So this means the most detailed and accurate version will usually get picked if it makes it through the review process first. Please know we value everyone's work but are constrained by system requirements.
If you are starting a new part, try to check if multiple people are also working on the same part, and consider building a part not yet in progress.
13 lipca 2026 22:11
Anyone have a Lipo just blowout like this mid flight? Lost power then video. Luckily at low elevation. Took about 45min to find the quad, got away with just one bent prop.
My only setting i had changed was switching the VTX from 200mW to 350mW as my video range was acting funny and not reaching as far as expected.
Not my favorite Lipos anyway... Good excuse to grab som R-Line V6 1000mah's.
-Make sure your firmware matches in the goggles and the VTX.
-Set your aspect ratio to 4:3 instead of 16:9, this gives gyroflow more to work with when stabilizing
-Use a tiny square shim of shrink tube beneath the cover plate to hold the antennas onto the board more securely
-Replace the antennas with any other LHCP antenna, stock are not great, I use the Ospreys.
- Consider setting up a custom background on your goggles, you can use fine particles to help focus the diopters faster.
29 czerwca 2026 06:51
29 czerwca 2026 06:50
29 czerwca 2026 06:28
29 czerwca 2026 06:26
Can someone please point to the precise RX / TX functions for GPS module pads in the builder? I've resubmitted the same part multiple times but it keeps getting rejected.
> Sees RX on schematic
> Types RX in the search
> Selects "UART - TX" from the list
> Submission gets bounced for not using UART
I'm completely lost, anyone else with this issue?
The GPS tag is not changeable since this is a gps module its added automatically.
Very cool
https://www.youtube.com/watch?v=i1IQXR6Rr4o