Welcome to Utah! Depending on where you’re at I’m sure there are many places for long range, but I don’t have much experience with long range flying. The Salt Flats are huge and flat, or there are mountains all around.
Is your camera angle already as low as it can go? FPV drones typically have the camera angle at around 20-35° because, when you're flying forward, it angles the drone down so the camera can see what's ahead.
If you're recording stationary or slow-moving subjects, you might be better off with a DJI Neo or similar drone. Otherwise, I'd try increasing your speed and using Acro mode instead of Angle mode (if that's what you're using).
I have an Ender 3 (which is likely the model he's offering if it is an Ender), and I love it. That said, it isn't necessarily a plug-and-play printer like Bambu Labs printers are. You'll have to do some tinkering and playing with settings to get it to print just right. 3D printing is a learning curve, and you'll be surprised at how many random issues you'll have to become familiar with.
The Ender 3 typically goes for just under $200 USD, and filament is usually $20 per kilogram. The printer and some filament for just $100 sounds like a good deal to me, and if you play with it for a few weeks and decide it isn't for you, you can probably get your money back by reselling it on Facebook Marketplace or elsewhere.
I don't think they ship until March of 2027, so I doubt anyone has them yet. They look pretty cool, and I love the idea of open-source hardware, though!
They exist, but depending on what your use case is, you might have to design something yourself. Flying an FPV drone with a negative camera angle is difficult, so you might be better off with a pre-built drone with a camera gimbal, a 360° camera, or a custom drone with two cameras, one for recording and one for flying.
It's getting pretty cold here pretty quickly, and we're expecting snow by the end of the week. I don't expect to be able to pull out the 5" for at least 3-4 months.
I would imagine an organized event would have channel assignments planned out ahead of time. They can also use tools like this one to find the best channels for a variety of pilots: https://www.diyfpv.com/resources/fpv-channel-organiser
Yep, I'd recommend cleaning up both the positive and negative pads and resoldering. Make sure you're holding the soldering iron against the pad and wire long enough that the solder can make a solid connection. It will not last if the pad isn't hot enough.
If the motors are feeling wobbly then it’s almost certainly the bearings having gone out. The bearings are supposed to hold the bell perfectly parallel to the stator so they don’t rub.
You can fly it like this, but the vibrations will likely get worse, and your motors will probably get hotter than they would before.
Did you disassemble the motors, completely removing the bell from the stator, when cleaning? If so, it is possible that your motor bearings are failing, and you might just have to get new motors to solve this problem.
It's difficult to give a good estimate. Many parts have sat at that point for a while because we've been making sure the builder is completely ready before releasing it (the community was much faster at building parts than we expected!).
Over the next week or two, we should be able to publish many more parts now that the builder has been released.
I've done the same oscilloscope and function generator kits! They're great for learning how to solder, and I've found the oscilloscope to be pretty handy in some other projects, despite its inaccuracies. I found these instructions on how to make the oscilloscope work with USB power, and there's a mod included at the end that can make the reading much cleaner, but I haven't had the time to try either mod yet: https://www.instructables.com/DSO138-USB-Power-No-Boost-Converter/
Laten we samen de lucht in gaan en de wereld van FPV-drones naar nieuwe hoogten tillen.