VitroidFPV

I'd be hesitant to recommend anything to anyone attempting to build a 14s rig as their first FPV build too

That board cannot run Betaflight, it uses BetaFPV's own firmware that's quite limited in what you can do with it... It might connect to their own Configurator, you could try that

Just throwing this out there - I'd love if the formatted text fields parsed regular markdown! (GitHub flavored preferably)

I'm used to formatting stuff that way, and some copy-paste replies I have also rely on it working like that. The formatting options in the UI work, but markdown would be nicer. Markdown in the profile description would also be nice :)

That's good to hear! If you want to go to newer Betaflight versions, make sure that you only flash with the OSD (Analog) option - remove the OSD (Digital) option if you want previous backups to work as expected - while keeping OSD (Digital) does not prevent analog OSD from working, it requires extra setup. This has been addressed in future releases of Betaflight Configurator where it is now an exclusive option that prevents the features from colliding

@Quadbeard89 the board was flashed with a HappyModel target, since you didn't mention otherwise, I'm assuming it's stock from Flywoo - so it should use a Flywoo target, most likely FLYWOOF405S_AIO

Go to the CLI tab in Betaflight Configurator and click `Submit Support Data`, then send the resulting ID in a reply

M2x7mm bolts https://www.racedayquads.com/products/m2-x-7mm-steel-bolt-10pack-for-t-mount-props

The motors should come with some, but they are easy to loose, so spares are always good to have

I assume @justin28 was asking about T-Mount props specifically, which have one hole for the shaft and one on each side for an M2 bolt

Run through the calibration process on the radio. If that does not work, set the "Stick Low Threshold" a bit higher. It can be found in the Receiver tab in Betaflight Configurator