Latestarter

Ultimo accesso: 8 ago, 03:48

Follower

Seguiti

Voti positivi

Post

Non c'è ancora una biografia...

Feed attività

18 luglio 2025 alle ore 00:19

Ha pubblicato un post

I have read that when using a DJI O4 Pro with an elrs system you have to remove the yellow wire on the connection from the O4 to the flight controller to stop interference between the two systems.

Is this correct?

7 luglio 2025 alle ore 23:22

Ha commentato il post di

Latestarter

Thanks for all the info and support.

A guy form Bathurst has reached out and offered to help me so if I can’t improve after some more practice I’ll take him up on his offer

You’ve created a real community of support and should be proud of what you’re doing, unlike some other forums that I’ve seen where they give Newbie’s a real flogging.

Have a great day

Cheers

Arthur

6 luglio 2025 alle ore 20:50

Ha commentato il post di

Latestarter

I’ve tried a range of temps from 350 to 420

6 luglio 2025 alle ore 08:56

Ha pubblicato un post

Soldering tips

I’m building my first drone and have watched several YouTube videos on soldering including JB and have practiced on practice boards with reasonable success but when i tried to solder my Speedybee ESC I just can’t get the solder to stick to it, I’ve tried with flux and without it. My soldering station has temperature control and I’m using 60/40 solder. I’m concerned that I’m going to wreck my ESC if I put too much heat into it.

Any tips