Latestarter

Última visita: 8 ago, 3:48

Seguidores

Siguiendo

Votos positivos

Publicaciones

Aún no hay biografía...

Feed de actividad

18 de julio de 2025 a las 0:19

Ha creado una publicación

I have read that when using a DJI O4 Pro with an elrs system you have to remove the yellow wire on the connection from the O4 to the flight controller to stop interference between the two systems.

Is this correct?

7 de julio de 2025 a las 23:22

Ha comentado la publicación de

Latestarter

Thanks for all the info and support.

A guy form Bathurst has reached out and offered to help me so if I can’t improve after some more practice I’ll take him up on his offer

You’ve created a real community of support and should be proud of what you’re doing, unlike some other forums that I’ve seen where they give Newbie’s a real flogging.

Have a great day

Cheers

Arthur

6 de julio de 2025 a las 20:50

Ha comentado la publicación de

Latestarter

I’ve tried a range of temps from 350 to 420

6 de julio de 2025 a las 8:56

Ha creado una publicación

Soldering tips

I’m building my first drone and have watched several YouTube videos on soldering including JB and have practiced on practice boards with reasonable success but when i tried to solder my Speedybee ESC I just can’t get the solder to stick to it, I’ve tried with flux and without it. My soldering station has temperature control and I’m using 60/40 solder. I’m concerned that I’m going to wreck my ESC if I put too much heat into it.

Any tips