Latestarter

Zuletzt gesehen: 8. Aug., 03:48

Follower

Folge ich

Positive Bewertungen

Beiträge

Noch keine Biografie...

Aktivitätsfeed

18. Juli 2025 um 00:19

Hat einen Beitrag erstellt

I have read that when using a DJI O4 Pro with an elrs system you have to remove the yellow wire on the connection from the O4 to the flight controller to stop interference between the two systems.

Is this correct?

7. Juli 2025 um 23:22

Hat den Beitrag von

Latestarter

kommentiert

Thanks for all the info and support.

A guy form Bathurst has reached out and offered to help me so if I can’t improve after some more practice I’ll take him up on his offer

You’ve created a real community of support and should be proud of what you’re doing, unlike some other forums that I’ve seen where they give Newbie’s a real flogging.

Have a great day

Cheers

Arthur

6. Juli 2025 um 20:50

Hat den Beitrag von

Latestarter

kommentiert

I’ve tried a range of temps from 350 to 420

6. Juli 2025 um 08:56

Hat einen Beitrag erstellt

Soldering tips

I’m building my first drone and have watched several YouTube videos on soldering including JB and have practiced on practice boards with reasonable success but when i tried to solder my Speedybee ESC I just can’t get the solder to stick to it, I’ve tried with flux and without it. My soldering station has temperature control and I’m using 60/40 solder. I’m concerned that I’m going to wreck my ESC if I put too much heat into it.

Any tips