14sem. (modifié 14sem.)
Message de discussion
Just had this while flying my 75 mm whoop. It started to have these desyncs(if that is a desync) 3 weeks ago. Some times it happens, some times it doesn't. How can i fix it and make sure it wont happen again? Thanks. (I couldn't get the dvr out of the sd card so i recorded it with phone. I hope it is ok)
14sem.
it looks like something is happening with the back right motor. Have you checked if there is something wrong with the cables there? if the motor is direct soldered it could be a loose solder joint. (that was the cause for this problem on my 5inch drone)
Répondre
14sem.
Auteur
There is motor plugs. Many ppl say you should remove them maybe thats the case? But i am not very good at soldering(accidentally burned 2 aio camera/transmitter)
Répondre
14sem.
the plugs should not be the problem. perhaps it is just a broken cable? I would probably just get one new motor und try switching it. Worst case, if it does not help, you have a spare one for the future^^
Répondre
14sem.
Desyncs are an easy fix. Watch this short video. https://www.youtube.com/watch?v=jWdkl0EHkyU&t=96s
Répondre
14sem.
Auteur
I will look at it. Thanks!
😁 1
Répondre
14sem.
Dirty motor or bent shaft sounds pretty likely. Tiny whoops get crashed a ton and collect hair and other junk when you fly inside
Répondre
14sem.
Auteur
Is there any way i can clean the motora without opening it?
Répondre
A
Laisser un commentaire