Publicación en el foro
I've been playing around with the builder some more and I've gotten a review or two. I understand *whyyy* they want me to put capacitors and chips and all the pinouts and such. However, a lot of times that stuff isn't documented. I don't know what every little component is, or what the specific pinout of a plug is, or what a random, unlabeled pad is. That stuff is simply not documented. At some point I simply cannot comply with the standards.
Note: I could guess at capacitors and resistors and such, they usually look the same. However, I refuse to add something unless I'm 99% sure that it is correct. I think these expectations taking away from the kind of volume the builder needs. I think the blanks will be filled in as needed eventually.
I understand your frustration with the expectations, we want every pad to be as accurate as possible because people will be using this tool to plan their drones wiring. If it says the wiring is right in the builder, but it's really wrong, they could end up frying their new components, so we try to be as accurate as possible.
Deja un comentario