Troubleshooting AM32 ESC Issues on 5-Inch FPV Drone
My problem is basically the same as the Redditor’s post. I replaced my old ESC with an AM32 ESC and I’m having the same problem, but nobody answered him.
I read some of y’all’s advice. Someone said to just replace the board, but this is a brand-new board that works. Someone else said to change the voltage limit if I’m using LiHV batteries, but this is a 5-inch, so I only really use LiPos.
Perhaps the screenshot of the Redditor’s post can explain my problem better.😭😭😭
🙃 1
6sett. (modificato 6sett.)
did you reflash everything when you installed the new esc just to reset everything?
it could be the current scale or need a manual recalibration
💯 1
Rispondi
6sett. (modificato 6sett.)
What setting (number) do you have in betaflight on the amperage meter? If it is set to 290 with 0 Offset then this would be correct. Make sure to set the meter source to onboard ADC if set to ESC sensor.
Rispondi
F
6sett.
Autore
:/
Rispondi
6sett.
Set both to onboard ADC this would be the normal setting for any skystars FC stack. I do use multiple ones from them and all are set the same way without issues
Rispondi
F
6sett.
Autore
I’m pretty sure I tried that and it didn’t work but I’ll try again.(thanks for the help btw)
Rispondi
A
Lascia un commento