T
11 t. (zaktualizowano 11 t.)
Wpis na forum
I built my first custom drone without soldering which is all plugs. Matrix v2 board, Happymodel se0802 19000kv, Happymodel mob 7 v3 frame with C03 cam. After assembly, done tuning in betaflight and bind phrase. When I tried flying it, it just lift off and if im under 40% throttle nothing happens but when it’s over 40% it shoots up by itself and take over without listening to my stick inputs. I watched some videos and they said that it was because of unfiltered, filtered loose screw that made vibrations? My kwad had no problems like that. Any ideas?
11 t.
Well it can have multiple reasons why it is doing that. Loose screws, cracked/broken frame, PID and filter tuning, wrong motor order, wrong motor direction, wrong fc direction,...)
Can you post a screenshot of your PIDs and filters in Betaflight so we can rule out a simple tuning issue (a too aggressive tune).
Can you post a screenshot of your PIDs and filters in Betaflight so we can rule out a simple tuning issue (a too aggressive tune).
Odpowiedz
T
11 t.
Autor
btw the same thing happened to my Air 75 after i flashed the firmware of the air 75 v1.( i stopped using it and built an new one because when i was soldering i might have burned something on the board), idk what is happening bruh, is it my TX problem?
Odpowiedz
A
Dodaj komentarz