J
Drone Won't Arm After Battery Change - RX_FAILSAFE Issue
i just got my radiomaster pocket and i went throug all the updating on my drone and radio and got a few flights out then I went to change batteries bc I had drained the current one and my drone wont arm anymore in beta flight the setup tab shows the RX_FAILSAFE flag but the cli shows the RXLOSS Flag my radiomaster pocket and BetaFPV ELRS Nano show connection and that they are bound I've checked the pads and they are soudred to the right placed(RX -> TX, TX -> RX) on the flywoo geko f411 v2.2 what could be wrong?
70 W
please confirm how you know they are bound? are you getting stick input in betaflight, or telemetry lost voice que etc when depowering the drone?
Antworten
J
70 W
Autor
i am getting the telemitry lost sound when unplugging the drone and the receiver is showing solid blue to indicate a connection with the remote
Antworten
70 W
@Jacka328 on the drone are the correct ports enabled and on the reciever tab are all the details correct, eg - correct provider, urarts or spi etc.
Antworten
J
70 W
Autor
@uavfutures as far as i can tell yes I checked the protocol and everything I have tried enabling the serial rx but it doesn't stick and will just imitally disable apon reboot
Antworten
J
70 W (bearbeitet 70 W)
Autor
Diese Antwort wurde gelöscht und ist nicht mehr verfügbar.
70 W
Based on the info so far I would check the settings on receiver tab in betaflight it still set asx CRSF.
Antworten
J
70 W
Autor
Yup i checked the betaflight reciver settings and the actual recover settings through the wifi config
Antworten
J
70 W
Autor
this could be something i was messing around in beta flight and the the motor testing and only motor 1 will spin when betaflight says they should all be spining
Antworten
66 W
when you bind, ensufre that the you are not locking the model. there is a security option in the receiver or sometimes in the radio where you tell the radio/receiver to ensure that only that radio connect to the receiver. so even that that you are bound and using a different model it will not work.
Antworten
A
Kommentar hinterlassen