Yes, you can do that. On almost all flight controllers (FCs), the 5V pads and GND pads are internally connected to the same power rail and ground plane.
The main limitation is your FC's 5V voltage regulator (BEC). Make sure the combined current draw of all connected components does not exceed the BEC's maximum amp rating (typically 1A to 2A). Overloading it can cause the 5V rail to overheat or shut down mid-flight.
Key Risks & Limitations to Keep in Mind
- Brownouts: Exceeding the 5V BEC limit does not always fry the board right away. It often causes a sudden, temporary voltage drop ("brownout"), which can force your receiver (RX) or flight controller to reboot mid-flight.
- Minimum Voltage Thresholds: Most FCs and receivers run on 3.3V internal logic stepped down from the 5V rail. If the 5V rail dips below roughly 3.8Vā4.2V for even a few milliseconds, the processor will reset.
- Current Spikes: High-draw peripheralsāsuch as multiple digital servos, bright LED strips, or analog VTXs powered off the 5V railācan pull sudden bursts of current during sharp maneuvers.
- BEC Types & Heat (Linear vs. Switching):
- Linear BECs (common on older or micro FCs) dissipate excess voltage as heat. Higher battery cell counts (like 4S or 6S) make them overheat much faster and drop voltage under load.
- Switching (Buck) BECs (standard on most modern FCs) are far more efficient and run cooler on 6S, though they will still brown out or shut down if you exceed their current limit.