Hey guys,
So the last time when I flew my happymodel mob6 hd it disconnecting suddenly to the goggles.
And now the vtx don't connect to my goggles anymore I tried a few things. Flash firmware, checked if it is in pit mode, different antennas, diffrent mw and diffrent channels and nothing works.
The connection to the controller is fine I can arm the drone but no video connection.
They are two lights on the aio5 board normally the red and blue light are steady. Now the red light is steady and the blue light is flashing 2 times then a break and then again 2 times and so on.
There is troubleshooting page where it says camera. but the last time I broke a cable to the camera the vtx still connected to the goggles but there was no picture only.
Maybe someone knows something or have similar issues with an hdzero vtx and has a solution.
Kind regards
Sennad
I don't know anything about hdz. I assume you tried rebinding goggles? Was there a crash?
Since it says that the camera is not detected, I would check the wiring. Then maybe try a new camera. If that doesn't work, the vtx in the aio might be dead.
Are you 100% sure that the VTX antenna is plugged into UFL connector on VTX? Are you 10000% sure that you didn't power up the VTX while annetna was not plugged into the UFL? Do you have any other antenna that you know is working correctly - can you plug it in? If you're having connection problems - that might be the case. Your Mob 6 - is it built on HDZERO AIO or standa alon whoop VTX? The worse case scenario: you've powered up drone without anntenna plugged in and you've fried the VTX.
I would check the antenna, change the antenna and see if it worked, if you have an extra VTX - change the VTX to see if that works.
Good thing with HDZERO is that you don't need to bind the goggles to the VTX.
So I changed the antenna a few times and I never powerd it up without an antenna. It's an Aoi5 board the new one.
I have also an 75mm happymodel with the Aoi5 and it works perfektly fine still connects the vtx to the goggles without an camera connect to the vtx . So that means that my vtx from the board from 65mm not connecting to the goggles.
I tried to change the cameras but that also didn't helped. Yeah I think the vtx is done on the board.Everything is working fine motors arming elrs only the vtx will not connect to the goggles. And it was suddenly in the middle of a flight.