Solutions for Downward-Tilted FPV Camera Configurations
Does anyone know if there is any solution out there, like special 3d printed component or specific frame, for a configuration with the viewing camera slightly tilted downwards instead of the usual tilted upwards?
They exist, but depending on what your use case is, you might have to design something yourself. Flying an FPV drone with a negative camera angle is difficult, so you might be better off with a pre-built drone with a camera gimbal, a 360° camera, or a custom drone with two cameras, one for recording and one for flying.
Im working on this problem for my municipal services drones. You dont want your main camera tilted down, you'll barely be able to move when flying as the drone tilts forward to go forward, you wont be able to see where youre going. Consider a 2 camera setup with a cam switcher or look at ways to build/mount a gimbal/servo onto the frame.
I have started flying 2 weeks ago, have done maybe 10 sessions, and I have noticed watching the recordings that I care 99% of the time what's in the lower half of my screen. Above that is the sky most of the times and I am most interested in what's below.
Is your camera angle already as low as it can go? FPV drones typically have the camera angle at around 20-35° because, when you're flying forward, it angles the drone down so the camera can see what's ahead.
If you're recording stationary or slow-moving subjects, you might be better off with a DJI Neo or similar drone. Otherwise, I'd try increasing your speed and using Acro mode instead of Angle mode (if that's what you're using).
My camera angle is as low as it can get on a FlyFish. I understand the camera is tilted upwards to be able to see where you are heading. I am only flying in Acro mode. But I can't take a good look at static ground from above.
Anyways there is lots of room for tinkering.
I might get a camera on a gimbal controlled by head movements or maybe I'll drill a new hole to the frame to mount the camera at 0 or -10 degs.
Odpowiedz
Musisz być zalogowany, żeby odpowiedzieć na ten komentarz.