Mobula7 Not Arming After Battery Connection - What Am I Missing?
I just received my Mobula7... its now connected to the DJI goggles yeah... In betaflight I see my RadioMaster Boxer i see Pitch, Yaw etc moving when i move the control SO its basically connnected... I see also the ARMED being AUX1 reacting in betaflight BUT It does not arm when I connect the battery!! Why do you think? What am I missing!!??
Ref: Happymodel Mobula7 80mm 2S Micro Whoop FPV Racing Drone BNF with CrazyF4HD ELRS FC DJI O4 Air Unit HD Digital System - DJI O4 ELRS 2.4GHz
83 t.
Does the arm mode turn red in betaflight when you arm? On the OSD are you getting any errors when you press arm?
Odpowiedz
83 t.
83 t.
Autor
No error message anywhere, on the Radiomaster I tried toggling "model Match" with no results..
Odpowiedz
83 t.
No, i mean in betaflight. On the OSD tab, "warnings" is at the bottom and tells you errors in osd.
Odpowiedz
83 t.
Are you plugged to usb while trying to arm?
Odpowiedz
83 t.
Autor
No! That much I kknow!
Odpowiedz
83 t.
Hope you can work out the issue and get it sorted. It's all a bit overwhelming This is also what I fear when I get my FPV stuff. Persevere is all you can do. Good Luck.👍
😅 1
Odpowiedz
83 t.
I HIGHLY recommend Bardwell's beginner videos. They helped me a ton when I was starting out
Odpowiedz
83 t.
Have you changed your maximum arm angle (degrees)?(180°) if not. That always gets me when building new drones. Also check your failsafe. If the gps rescue is on click the allow arming without fix. I know it’s a tiny whoop but worth checking
Odpowiedz
D
83 t.
Look at betaflight setup page, "arming disable flags" you should get a clue there.
Odpowiedz
83 t.
My Mobula 8 would do this and I had to activate the flip switch then arm and it would spin up
👍 1
Odpowiedz
83 t.
Autor
I found the solution thanks @Toclose for its support!! It was my throttle that was never at zero.. see this tutorial by JB here https://www.youtube.com/watch?v=YjZX89ujgak
Odpowiedz
A
Dodaj komentarz