How to Prevent Motor Wires from Breaking on Air75 II
New to the hobby and recently bought an Air75 II. The motor wires keep breaking off the main boards soldering and Ive had to resoder once already and just now I snapped another wire. Is there a good way of preventing this? Im out of town so I’ll have to wait to solder it when I get back but I was looking forward to flying it where Im visiting.
🫣 2
2 t.
ohh we had this a lot in office, following this thread 😁
Odpowiedz
2 t.
bro same thing happened to me but i just bought a new one
Odpowiedz
2 t.
Secure the wires to the frame with some dental floss
👍 1
Odpowiedz
1 t.
there isnt much you can do on that frame, you can try to make sure the wires are nicely twisted together and use some cloth wire harness tape around the bundle to give them some more protection. In this case, I would personally swap it to the meteor75 frame or another one that offers a bit more protection/durability and that has a duct arm near the wires that they could be more easily taped to.
Odpowiedz
S
1 t.
maybe secure the wires with thin thread/dental floss and E6000 applied closer to the pad
Odpowiedz
B
1 t.
at least there not plugs 😁
Odpowiedz
A
Dodaj komentarz