I have ordered stack of parts based on youtube video and 5 inch drone frame with 1500 4S battery pack. I Have now tried to draft wiring diagram with help of software and AI and some videos how wiring should be done.
Just in case i also have smoke stopper ordered.
If you find any mistakes on this i would be happy to have them pointed out as i am just learning but at least it seems valid for application which is btw amazing tool!
5 inch drone draft circuit
Volledig schema openen| Categorie | Freestyle |
|---|---|
| Likes | 10 |
| Weergaven | 1012 |
| Videosysteem | Analoog |
Teken je eigen build
Zet je onderdelen in de Drone builder en laat de bedradingsassistent uitzoeken wat waarop aansluit.
Drone builder openen
Reacties (3)
Ttpetersons This is pretty cool. Make sure to update this thread with IRL photos once your build is done. 🔥
BTW, is that a common practice to power your buzzer from VTX? Why not using the pads on the FC? Ssimusami Auteuri dont know how common it is . Problem seems to be that if i power buzzer from FC then i get in software error that railing apacity to supply voltage is exceeded. I just couldnt get that annoucement go away no matter what power output i tried. Only way was then to power VTX from FC 4V5 output which gives 4.5V to VTX. According information in application VTX voltage is between 3.7 -5 V so i am not fully sure would 4.5V be ok? Ssimusami AuteurThis is just my first build and learning as i go. I am now going to weekend course of drone building so i might get answer there as whole weekend saturday&sunday is about theory and different drone componments etc. I am sure i can get answer there to my question :)
Je moet ingelogd zijn om op deze reactie te reageren.