Successful Maiden Flight of My 2.5 Inch Build - VLOS Video
Had a great maiden flight with the 2.5 Inch build. Here is a VLOS flight of it before I flew it with FPV.
Flight Video link: https://youtu.be/E0-IHI4k4CI?si=gOnaYA4UwNhj9r1A
🔥 4
41sett.
That's some serious skill flying line of sight. 🫣 the frame is doing good haha
Rispondi
41sett.
Autore
Haha, I was careful with the throttle at first but was also surprised how the 3D printed frame was able to withstand those punch outs 😀
Rispondi
41sett.
Very nice indeed! I wouldn't be able to fly like that VLOS. It would just be gone and crash 🤣
I m able to do short tuning flights this way but that's about it. Congrats on making it fly that good!! I switched to diy carbon fiber because I did have quite a few issues with my printed drone. Tuning it was awful but it flew too.. until I crashed it. Again good job on making it work like that
👍 1
Rispondi
41sett.
Autore
Thanks, I've flown VLOS for many years and also watched quite a few of Quadmovr's videos. I had to turn the master slider down to 0.6 and motor idle to 3% for it to not flip out uncontrollably. 😅
🤟 1
💯 1
Rispondi
A
Lascia un commento