84sett. (modificato 84sett.)
5-Inch and 3.5-Inch Quads with Custom 3D Printed Cooling System
My 5 inch and 3.5 inch (got the 04 pro on the 3.5) on my new 3D printed mini cooling system for when I’m messing with the engines and vtx in betaflight. I just pulled the quads down to take the picture so don’t think I fuck with the engines with props on like this lol!
🤘 4
🧠 1
👍 1
🧨 1
84sett.
I like that. My area is a little crowded so I just set mine next to me. Mine is also a little different, I made the stuff in red with tpu to keep drones off the fan and airflow through the bottom with standoffs.. My O4 overheated while using a 5v fan, so I got a stupid powerful one, that I never turn all the way up. Says it'll do 318cfm @64db, don't need it.
👊 5
Rispondi
84sett.
Autore
Better to have too much than not enough that set up looks dope!
Rispondi
84sett.
Yours may be more effective, moving air across the boards. Mine just hopefully sucks it out at high speeds. But thank you.
👍 1
Rispondi
84sett.
Autore
As long as they don't overheat, it's all good!
🤘 2
Rispondi
84sett. (modificato 84sett.)
Autore
Questa risposta è stata cancellata e non è più disponibile.
A
Lascia un commento