Publicación en el foro
My whoop isn’t taking off and I can only use the speed bee app all props spin and are in the right direction but it just goes to the right like spinds can anyone help
23sem
Did you recently change anything about the configuration of the drone? Like tweak settings, install a preset, or reflash the FC? Does it work in other flight modes like angle or horizon?
Responder
J
23sem
Autor
I’m not sure I’ll look
Responder
23sem
Do you mean it freaks out and spins to the right when throttling up? If so than check your motors tab. Check if you got bidirectional dshot enabled. Also check (depending on prop spin direction) if you enabled "motor direction is reversed" if using props out instead of props in.. if props in untick it. And I would also check if the motor order is correct.
Responder
J
23sem
Autor
I’ve got all that done when I throttle up it moves clockwise a little bit then the motors stop
Responder
23sem
Well it stops to protect the ESC if a drone freaks out. So it's good that it does this. I recommend to check all screws.. a loose one can create vibrations which the gyro tries to fight. A cracked frame could also be the issue..
Responder
J
23sem
Autor
I just got a brand new frame
👍 1
Responder
23sem
@josh Aha, and have you made sure you put the flight controller back in the right orientation (front facing front, right side up)? If you're not sure check the 3d model on the main page of the betaflight configurator and turn it in all axes (pitch, roll, yaw). If one of them doesn't correspond to the movement you're doing, you've got your board in the wrong orientation.
👆 1
Responder
A
Deja un comentario