1sem
Help! Right Side Motors Not Spinning on New FPV Build
Help guys,
I have a new build and the motors on the right side won't spinning.
But when I plug the battery on the ESC to check the motors they are spinning.
I calibrate them but still nothing, they don't spin.
What could it be?
1sem (editado 1sem)
1: Check your motor mounting screws and make sure they are not protruding in to the motors working space.
2: Double check your soldering to make sure its fully contacting the pads, and make sure nothing is bridging solder to other solder, also make sure each solder piece is not touching something like a chip or a heat sink or grounding.
3: Make sure the cables are properly soldered on the motor side.
4: Check the cable connecting the FC to the ESC, if you have another try swapping it out.5: Try flashing the bios on the FC or updating it.
If that all is good then odds are part of your stack/AIO is dead.
Responder
A
1sem
If all that was said above is true and its sill not working try turning up startup power on esc configurator
Responder
1sem
Autor
How's that?
Responder
1sem
Is it in turtle mode?
Responder
1sem
Autor
how/where can I see that?
Responder
1sem
Your modes on your receiver. Do you have one set for turtle mode and is it activated when you start up. That will def cause only two motors to spin.....
Also when you plug in the beta or whatever you are using does all 4 motors making tha chiming noise and kind of twitch while making that noise
Responder
1sem
Autor
I'll check but im not sure.
Responder
A
Deja un comentario