Help Needed: VTX Not Saving on UART 2 with SmartAudio
Ok family. I need help.
VTX should be on UART 2, protocol SmartAudio. I can only get UART 2 to save if protocol is set to MSP and Display Port. I can't load the VTX table.
😮 2
🤔 1
74sem
Commenting so I can follow along for troubleshooting when I eventually run into the same problem.
👍 1
Responder
74sem
Autor
Support said that UART is correct, but the protocol should be Smartaudio. If I set it to smartaudio and save, it reverts back to no uart enabled.
Now, I am not getting a message that says no VTX detected. Band, channel, only option is none. Load the VTX table from Darwin's site and it errors out every line.
🤔 1
Responder
74sem
Autor
I was thinking of tagging you
Responder
74sem
@proantifpv For troubleshooting's sake: what if the UARTs are incorrectly labeled? What happens if you try on another one?
Full disclosure: I've been scared to fuck w/ my VTX table or even update BF on my rig too much because it doesn't actually broadcast on the channel you config it for. When I set my VTX to use R8, it actually broadcasts on B5, so I wouldn't be surprised if similar inconsistencies extended out to their other BNFs.
Full disclosure: I've been scared to fuck w/ my VTX table or even update BF on my rig too much because it doesn't actually broadcast on the channel you config it for. When I set my VTX to use R8, it actually broadcasts on B5, so I wouldn't be surprised if similar inconsistencies extended out to their other BNFs.
Responder
74sem (editado 74sem)
If I understand the problem I think the reason that you cant put a Vtx table into the drone is because you do not have the uart set to smart audio. And the reason uart 2 does not stay on smartaudio might be because (if soldered the VTX into the FC) you maybe soldered the tx to tx and Rx to Rx instead of tx to Rx and Rx to tx.
😮 1
Responder
74sem
Autor
Ah ha
Responder
74sem
@proantifpv Did ya get it ironed out?
Responder
D
74sem
You're not turning on the "configuration/msp" in the first box of uart 2 are you?
Responder
74sem
Autor
I can't believe how much I overthought this. The VTX is soldered fine. It's an issue with BF update and hardware incompatibility. Trying to figure out how to load the OSD without reverting back to BF 4.1.1
Responder
D
74sem
@proantifpv So, did you get smart audio to stick on uart 2 and vtx tables loaded?
Responder
74sem
Autor
I did. In the Video tab, I'm still seeing False under ready, but I also haven't battery powered it. Haven't checked with goggles either. Fingers crossed no rollback!
Responder
74sem
Autor
One other important edit- I was trying to load the VTX table through DFU/CLI mode. Thankfully, a screenshot pointed this out and doing it in the Video Trasmitter tab made UART 2 stick with SmartAudio.
👍 1
Responder
A
Deja un comentario