11sem (editado 11sem)
AIO Not Displaying Correct Voltage and Current - Should I Replace It?
A few months ago my aio just decided not to show any correct power-related information. Voltage is always displaid between 0V and 1V. and current at 0A I think. except that everythin still works fine. (just somehow the motor beeping function to find it doesnt but I think that doesn't matter). In my opinion it's no problem I can fly with the timer but should I get a new aio for some reason?
11sem
Did you check in betaflight if the sensor is set up correctly? You can recalibrate it if necessary. Otherwise it will fly fine. The risk is that you could damage your lipos as it won't trigger any warnings this way. So it could be a fried voltage regulator or just a betaflight mismatched setup. I would check betaflight first. Than if you got a multimeter check if any of the regulators is dead. Btw dirt on the board could create a short.
Responder
10sem
Autor
Thank you really much!
Because I really often disassembled my quad and I don't think that's good for any part, I decided to clean and test my AIO next time I disassemble it. I will also check if I can fix it with Betaflight, but I think that won't work because it was already set up and working. I am really sure I won't buy a new AIO because I have already flown like this and measured the voltage with a LiPo checker, but the batteries were all fine.
👍 1
Responder
11sem
The save way is to replace it
👍 1
Responder
A
Deja un comentario