Forgot Heat Shrink After Motor Swap - Build Spec Inside!
When you forget the heat shrink after swapping a motor..
😂 Happens every third time without fail.
Build Spec:
BQE RipSqueak OG 3"
1504
Analog - Rush Tiny Tank
👍 2
🟣 1
😆 1
🙃 1
90sem.
I did this on my last build. think i realised only after 2nd motor 🫣
😂 2
Répondre
90sem.
Auteur
@tpetersons Humbles me every-time. 😂
Répondre
90sem.
I ended up using liquid rubber and boy do I regret it after some crashes and needing to resolder.
🤥 1
Répondre
90sem.
Auteur
@Hashbrown Oh NO! Yeah that sounds like an absolute nightmare, I have only used liquid tape a few times and I considered it permanent.
Répondre
90sem.
Well I also used to do this, learned this from Oscar’s guide long time ago 😁 just a prop and some tape, worked just fine.
💯 1
Répondre
90sem.
Auteur
@tpetersons Such a great tip!
I had a local pilot show my this a few months back, totally blew my mind & worked like a charm to protect my 5" motor wires when I was out of race wire/LED. He also used it to slide disarm by hot gluing them under his motors/arms.
Love learning from others!
Répondre
90sem.
@CMYK_FPV nice, im putting slide disarm in my bucket-list 😆
Répondre
A
Laisser un commentaire