84 W (bearbeitet 84 W)
Radiolink ELRS Module Binding and Flashing Questions
Well I'm completely stumped.
I stupidly bought a radiolink elrs module instead of radiomaster and I can't seem to find a proper target in the device category of elrs configurator to flash it.
Do I need to flash it?
Can I just bind to my damn receiver and go flying?
Thanks
I have a Radiolink ATA nano 1w Elrs module
Speedybee nano elrs receiver
Radiomaster zorro 4in1
84 W
Autor
Well I managed to connect the module to the reciever, luckily they both have bind buttons.
If anyone knows anything about this module, especially how to reflash with a bind phrase please hmu!
Cheers
Antworten
84 W
It should have a webui, you can set the binding phrase there.
If the TX module and RX are on the same major version (e.g. 3.x.x) then the should be able to be bound.
If the TX module and RX are on the same major version (e.g. 3.x.x) then the should be able to be bound.
Antworten
84 W
Actually your first image looks like the webui, look for the 'Binding phrase' section:
Enter your binding phrase there and select 'Save' down the bottom
Enter your binding phrase there and select 'Save' down the bottom
Antworten
84 W
Autor
Thank you, I was still under the impression I had to fully reflash for that to save my phrase.
I spoke with radiolink and they said it's a new product and they haven't released the firmware yet but it is running 3.3 so I should be ok for a while.
Thanks for your help!
Antworten
A
Kommentar hinterlassen