Issue with mamba f405 mk3 basic motor 1 cuts soon as throttle is raised. Stack is 6 years old and used to flip out on old firmware running 4.5 betaflight now this issue switches motor 4 once but it's now only doing it to motor 1. Am I missing something simple or it's a little more complex for a beginner fpv freestyle race build drone xing 2208 2750kv motors flysky receiver fs-x6b
Transmitter fs-i6x 10 channel.
To troubleshoot this issue, firstly swap 2 motors and see if it is still happening.
So if it is a motor issue the same motor should do the same thing in the new position. If it si the ESC the motor in the same position on the quad should show the same issue.
I did this on my qaud yesterday and worked out it is the motor.
I tested it in betaflight by powering up the motor and see if it worked correctly or not.
That definitely sounds like the ESC is the issue. I would assume this was a Blheli_s ESC. You could try flashing to Bluejay vie ESC Configurator https://esc-configurator.com/ to see if a bad settings. But I think you new new ESC.
Thats a great question when switching to bluejay comes up select pwm frequency 24 48 96 are what's listed.
Well to test it won’t make a difference but normally 24 or 48 on 5 inch quad.
I found a solution to this issue in betaflight the solution is by turning on bidirectional Dshot then saving it now motor 1 runs in betaflight as well under reorder motors.
Interesting, normally if that is on and you don’t have ESC firmware that supports it, it would not work correctly. But it’s good it is working now.
The bluejay has also help i think I'm un sure but found a video on YouTube betaflight motors won't spin try this!!! By FluentFPV
Now I'm getting it jumps in the air falls back to the ground due to all motors stopped crazy but getting some where with this drone
I also had to change direction in betaflight for some reason it when back to normal motors spin in
It would have reset when you flashed Bluejay. Also every time you run the direction wizard in betaflight it resets them all back to the 'normal' direction in ESC settings.
I did a motor swop. Now wants to go in to flip out but still motor one not running when throttle up but in betaflight it's the same on its own won't spin but with mater controller spins up fine. Drone been put away for years till I could work out what happening and why only motor 1 cuts out and others now rev out of control thats after the swop.