87 t. (zaktualizowano 87 t.)
TinyWhoop Motors Breaking: Has Anyone Experienced This?
Anyone ever had tinywhoop motors break like This? I don't even put force on the bell since I have a prop puller from WeBleedFpv
(Betafpv 0702 27000kv motors 1mm shaft) The motor bell broke off from the shaft hub
🫣 1
🤣 1
87 t. (zaktualizowano 87 t.)
Autor
I never really expected this to ever happen since the hub has 6 points of contact with the bell. I expected the bearings to wear out before anything like a broken shaft would happen posted it since I thought it was a bit disappointing
Odpowiedz
87 t.
Oof. That stinks. Sorry about your luck.
Odpowiedz
87 t.
That sucks. Did it break after a crash.
Odpowiedz
87 t.
Autor
I really don't know, it came off randomly while I was gently spinning the motor by its prop. I suddenly felt grinding after smooth rotation, even more unlucky.
Odpowiedz
86 t.
So, I doubt you're gorilla whooping anywhere today... have you ordered a replacement yet?
😅 1
Odpowiedz
86 t. (zaktualizowano 86 t.)
Autor
Just ordered some WeBleed Screamer motors 3 days ago.
Odpowiedz
86 t.
Very nice! I have those. Of course they strain the battery more at full throttle, but can somehow stay in the air longer...
I run them with gf 1208 props at 90% output and they fly like stock. I just need more stick time, big upgrade tho🔥
Odpowiedz
86 t.
Autor
Thankyou, i been trying to look for some props for them available on amazon!
Odpowiedz
86 t.
I can gift you a couple sets of 1208 props. I haven't been going through them at all. I do have the extra set that came with it too... and it's like if we're meeting up with all the stuff to complete a quad we may as well gorilla whoop that spot?
Odpowiedz
A
Dodaj komentarz