13 t.
Can I Fly My Whoop Without the C Pin?
New fear unlocked 💀
I was doing some indoor ripping then touched the floor. I couldn't made the quad get in the and when i went to check it, this is what i found. The "c pin" that hold the motor bell vanished for some reason. It may be that yesterday i cleaned 3 motors and that motor was one of them, maybe i couldn't put the pin properly. But the whoop can still takeoff. Should i fly like this?(Without the c pin)
T
13 t.
uhh for my recommendation, nah bruh cuz the momentum of the motor and props spinning at high speeds and crash after that, is either is gonna pop out and go missing or just get more debris in your motor bell and you gotta clean it again. btw, for ordination of the c-clips, is one on the motor shaft that is connected to the shaft( where the propellers sit on top or somewhere near there) and another 2 of it , a circle and a c-clip at the bottom of the motor. I got my used air 75 v1 and within 2days it broke. the solder joints got cut off and i didn't really know how to solder yet but i tried and im pretty sure that i burned the esc for that two motors. Now i have to get a new AIO FC. :(
Odpowiedz
13 t. (zaktualizowano 13 t.)
Autor
So i guess i'll just buy a new motor then?
Odpowiedz
T
13 t.
well, it depends if you lost your c clip or not... But in the USA for you guys, preferably is to get a brand new motor. Are the motor wires soldered on or is it using a plug? If you have soldering skills and confident that you can solder, go ahead, don't be like me and burn out my Aio fc G4 from my air 75 v1. 🫠;-)
Odpowiedz
13 t.
Autor
@tz3den i lost the c clip and i am not in usa. I am pretty bad at soldering. I burned 2 aio cameras with vtx.
Odpowiedz
T
13 t.
well if you lost the c-clip, then definitely get a new motor bud. My soldering was bad too but after some practice with LOTS of flux, i got it. Is not really perfect-ish, is just some mild soldering. Btw don't put the solder on the board for too long or else it will get burned like my aio fc. If the solder doesn't melt, take it off, tin it and try again. I'm just using a now brand solder set but i bought other stuff like brass sponge, flux, solder wire and xtra tips for it. I'm using a 1mm tip cuz my pads are really tiny.
Odpowiedz
T
13 t.
yup, no problem!
Odpowiedz
A
Dodaj komentarz