Flying My 3D Printed Drone - Need PID Tuning Help

I finally managed to fly a few packs with my 3d printed drone. It still needs some pid/filter tuning to e.g. minimize propwash

video was recorded with a runcam thumb2 using gyroflow.. (another tool I still need to learn)

https://youtu.be/_wjWzXXhjyg

🤘 5

DRBFPV

75sem.

Very smooth, nice rip. Impressed!

👍 1

Répondre

M4R5_FPV

75sem.

Auteur

Thanks. After I managed to make it fly I m preparing the the next step at the moment. I m going to create forged carbon fiber plates (with glass fiber layers) to replace the 3d printed ones.

Répondre

Laisser un commentaire

Prenons notre envol ensemble et propulsons le monde des drones FPV vers de nouveaux sommets.

Communauté

Catalogue

Support & Mentions légales

Politique de confidentialité

Conditions générales

M4R5_FPV

75sem.

Vidéos de vol

Flying My 3D Printed Drone - Need PID Tuning Help

I finally managed to fly a few packs with my 3d printed drone. It still needs some pid/filter tuning to e.g. minimize propwash

video was recorded with a runcam thumb2 using gyroflow.. (another tool I still need to learn)

https://youtu.be/_wjWzXXhjyg

🤘 5

DRBFPV

75sem.

Very smooth, nice rip. Impressed!

👍 1

Répondre

M4R5_FPV

75sem.

Auteur

Thanks. After I managed to make it fly I m preparing the the next step at the moment. I m going to create forged carbon fiber plates (with glass fiber layers) to replace the 3d printed ones.

Répondre

Laisser un commentaire