H
86sem (editado 86sem)
Need Help Troubleshooting Speedybee F405 V4 55A Stack Issues
Anyone have any ideas on how to help me troubleshoot this.
Speedybee F405 V4 55A stack
7" quad frame
2807 motors 1300KV @ 6S
SpeedyBee TX800 Analog VTX @ 5v pad
JHEMCU Receiver @ 4v5 pad
Runcam Phoenix v2 @ 5v pad
Scale is set to manufacturer recommendation @ 400 offset 0
Telemetry/Betaflight showing 45a current draw after I arm.
When I disarm it stays 45A but if I reboot it goes back down to .5-.6 until I arm again.
I have tried new firmware in esc-configurator - flashed to bluejay and turned on bi-directional
flies perfectly except for the controller warnings that I am out of power, when I am not.
thank you!
H
86sem (editado 86sem)
Autor
Esta respuesta se ha eliminado y ya no está disponible.
86sem
Open CLI and make sure everything looks correct. I had to do a save, dump and reload
👍 1
Responder
H
86sem
Autor
thank you! I started un-soldering things and with nothing on the FC I booted, powered off, then I attached the receiver and was at .7a - back to normal, then the VTX and still normal, im good now and all that changed was a re-solder.
I have a feeling it will be back!
👍 1
Responder
86sem
That’s awesome, never hurts to double check work. I have done it on multiple builds.
Responder
A
Deja un comentario