Modding the Skyzone Cobra X V4 for Better Comfort and Power

PROJECT WALKSNAIL COBRA X V4.

Here are some mods/3d prints I've been working on to make the Skyzone Cobra X V4 more comfortable when I have the Ascent VRX connected to them.

I have printed a rear head strap from the Oculus vr headset, mounted a 2x 18650 battery holder with power switch and run a retractable power cable to suit.

I was using a barrel splitter to power the VRX and goggles but was getting a low battery warning from the VRX. So I went back to the goggles being powered by its 18650 and the VRX powered by the 2 18650s.

Face foam and nose guard have been changed to DJI V1/V2 goggles. This has reduced the light leak down to nothing and a lot more comfortable.

The Ascent VRX is connected to the goggles with 2 velco pads attached to the back of the VRX and front of the goggles.