CKADRyan

Got this to protect the camera and on my 75 Pro. Thas when I found out the bracket doesn't fit the HDZero Lux, so 3D printed TPU 19mm bracket was needed to make it work

Been making Meteor 75 Pros and Mobula 7s with these motors since I bought an analog Meteor 75 Pro.

Baught CiottiFPV custom build to test out my VRX. Unfortunately when went to bind my VRX, the boards were just close enough to ark with the press of the bind button. It survived and swapped to a new AIO, and flying great over the past couple weeks. Getting about 3 minutes moderate freestyle flights with vtx on 500mw on a 1S 75 meteor Pro clone.

I started off this drone originally building out its BNF kit since they were sold out for a long time with HDZero Freestyle V2 VTX set up, and worked great. Later when I went to try out the Walksnail Moonlight kit with it. The VTX module is too big to fit into the stock bottom plate, and the Antennae shafts are too thick to fit into the dual antenna holes without modification. Luckily there are STLs available to print out to get these to work for the drone. overall good choice for a cheap cinewhoop frame.

Going from analog, to HDZero, to Walksnail through the VRX has saved me from buying another set of goggles to try another system. It's a bit of a process on getting the system synced firmware for the VRX and VTX when starting off, but after the first time, it's a lot easier afterwards. Thanks to D3VL for consolidating the firmware. https://walksnail.app/firmware

With it being able to swap from LHCP to RHCP, its a great option for an analog diversity receiver whichever you may use.

Work well enought on my systems, and got a spare set for my future build