R

Rob_FPV

Last seen: Nov 21, 17:57
Followers
0
Following
0
Upvotes
0
Posts
0
No bio yet...

Activity feed

November 18, 2026 at 3:02 PM

Commented on post
This is a very vague question, but apart from possibly messing up some settings, a CLI command shouldn't hurt anything. FWIW I have successfully used chatgpt to compile a custom inav firmware target for a generic FC and I'm not too bright, so LLMs can't be *that* bad.

October 28, 2026 at 4:48 PM

Commented on post
I'm pretty sure your FC is supported by ardupilot(double check the lit to be sure) but it wont work right out of the box as your quad FC 5v rail isnt intended to run fixed wing servos. You would need an external bec or power distribution to supply enough current to the servos; and you would need to remap the motor outputs, one for the throttle and one for each of the servos. 

Let's take flight together and elevate the world of FPV drones to new heights.

© 2026 DIYFPV. All rights reserved.