Ekerlee12

I fear I have messed up my motor selection and am trying to see if I can fix it through beta flight. I recently rebuilt my first quad from the ground up, a darwin tiny ape frame, Darwin f411 AIO, walksnail vtx and betafpv 1103 11,000 KV motors, and Im using 2.5 inch props. I think the motor choice was poor given I am running a 2s lipo, and its causing some desync when i try to do a punch out. One of the motors will seem to cut out. Is there a way to correct this in pid tuning, or should I just limit the motor output a bit while I shop around for new motors?

it seems that for a 2s build I should have been looking for motors in the 8000 KV range.

Another flight controller question I think I know, but want to confirm.

My new flight controller came with motor plugs I was hoping to use as my new motors have compatible connectors as well. I believe these smaller pads the arrows are pointing are set for the motor plugs. Is this correct? The FC diagram does not mention these holes at all.

Another Flight Video!

I turned airmode back on and I'm so happy I can actually go upside down without my motors cutting out.

https://youtu.be/7S2d90wDVvY

getting ready to a rebuild/upgrade of my drone, looking for advice on where to solder vitx power wire.

This is an f411 AIO for a darwin tinyape, and I am going to be putting a WS 1s lite VTX on as well, but I am not sure what pad to use to power the vtx? the vtx is rated for up to 3s as as well as the board, and I would like to make this a 3s drone. It looks like the board has a BEC as well so can I use the 5v and ground pads next to the RX and TX2 pads on the board?

https://www.youtube.com/watch?v=lFP_Xnmy_VY

Love the feeling of getting more confident in my flying

It was finally nice enough to get out and fly! Don't have ton of nest spots around me so so a big empty bus stop was the move